FSX addons

[Viking1]

I am looking for 3 addons for FSX

Milviz P38L Military
Milviz F4 Phantom
And
Flight 1 GTN 650/750
Thank you.

Milviz F4 https://thepiratebay.vg/torrent/12890900/[FSX_P3D]_Milviz__F-4E_Phantom_II   and  https://thepiratebay.vg/torrent/12907399/[FSX_P3D]_Milviz__F-4J__amp__F-4S_Phantom_II




Cool Thank you.

[p3drocks]

I am looking for 3 addons for FSX

Milviz P38L Military
Milviz F4 Phantom
And
Flight 1 GTN 650/750
Thank you.

Milviz F4 https://thepiratebay.vg/torrent/12890900/[FSX_P3D]_Milviz__F-4E_Phantom_II   and  https://thepiratebay.vg/torrent/12907399/[FSX_P3D]_Milviz__F-4J__amp__F-4S_Phantom_II




Cool Thank you.

Np

[Viking1]

I found a working link for the Milviz P38L Military.
It needs to be translated from russian.
Link is here.
https://www.t411.io/torrents/fsx-p3d-v1-...ck-edition

It's not russian, it's french.

And it works, although this is unfortunately the TacPack version, which means it has no droptanks or bombs/missiles models/animations included.
The standard version is on that site, but it's only for the P3D, and from what I see, the assholes coded it so that it won't run under FSX - even though AFAICS, the files are pretty much identical.



 That figures. Thanks for looking.

 

[72westy]

Would like to request both current versions (FSX/P3D) of the MIlviz F-4 E and J & S variants.

Also the Milviz MD-530F

---

Would like to request the following:


Flysimware's Mitsubishi MU-2B-60

VERSION 2.3 UPDATES: JAN 24, 2017

New Features
Updated installer with new features and better information

Bugs & Updates
Autopilot updated for bugs
GPU now needs parking brake on and both generators off to be active
Ground splash lights will now turn off with main bus below 8 volts
Alerter audio plays when you deviate 300 FT of the preselected altitude but not when you first pass through 300 FT of the preselected altitude
Turn Coordinator updated for accuracy
Sperry DME updated for instant calculation and mising dashes for no signal
HSI distance now shows all dashes for no signal

------------------------------------------------------------------------------------------

Flysimware's Bell 47G & Sioux H-13

VERSION 2.3 Released OCT 23, 2016

Floats model starter (fixed)
Exterior MASH model updated
-------------------------------------------------------------------------------------------

Flysimware's LEARJET 35A

VERSION 2.8 UPDATES: JAN 24, 2017

New Features
Updated installer with option to install 1 GTN 750 unit or dual GTN 750 units
Updated installer with new features and better information
The GTN 750 3D unit now have a click spot for the SD-Card
The GTN 750 units now comes pre configured with sound on and naviagetion pre-set
DME has new xml coding to display raw DME not just VOR/DME
DC & AC meters now have tooltips
Generator amperes meters now have tooltips
GPU now open a new small panel window to show when active or inactive
User manual updated for joystick keys list
Added more warning labels to main pabel (EMR PWR / PULL UP GPWS / NAV GPS MODE)
Altitude selector is now a Honeywell digital unit to match with the Honeywell altimeter
Overspeed warning now has 3 situations for an alert (IAS 300KTS under 8K FT / IAS 350KTS above 8K FT / Mach 0.81 above 25K FT / Mach 0.74 above 25K FT and autopilot off with Trim mode set to off or secondary)
The altimeter now displays altitude below sea level and will now display meters if you change the units of measure under general settings

Cold & Dark State
Standby battery switch off
Standby attitude gauge caged
Anti-Skid off
Thrust Levers set to cut-off

Switches & Knobs
Anti-Skid click sound was missing
Left click rather than middle click for Testing knob modes
Right click rather than middle click for both throttles cut-off
Windshield heat annunciator light now matches the correct switch position
Cabin pressure knob and cabin rate knob now have mouse drag
N1 reminder animation now counts up and down rather than just up

Flight Dynamics
Fuel burn rate updated
Intercepting ILS approach autopilot bank rate improved
Pitch, yaw and roll performance updated
Elevator trim max limit is now 10 degrees (Tooltip added to Elevator / Aileron / Rudder trim gauges)

Go Around
(AUTOPILOT ON) LVL, VS and ALTSEL modes active & pitch 9 degrees up
(AUTOPILOT OFF) All modes off, flight director pitch 9 degrees up

Bugs & Updates
Cabin pressure selector gets stuck (FIXED)
Generator amp meters will now have a higher charging value for more accuracy
Generator 2 amp meter was displaying generator 1 amps (FIXED)
Spoilerons will flash spoiler annunciator light with flaps above 13 degrees rather than full flaps. Solid light for spoiler only.
Alerter light is on within 1000 FT of the preselected altitude, and will remain illuminated to within 300 FT.
Alerter test now plays audio as well as illuminates
Alerter audio plays when you deviate 300 FT of the preselected altitude but not when you first pass through 300 FT of the preselected altitude
Radar options updated with new instructions in PDF format
Missing reference marker for the slip indicator ball
GPU now needs parking brake on and both generators off to be active
Vas Patch is no longer available / Night lights now use less memory
Recognition light bulb will now turn off with main bus below 8 volts
Ground splash lights will now turn off with main bus below 8 volts
Control panel 2D light functions from the GNS model only (FIXED)
Attitude reference bar changed from yellow to orange
Backup altimeter is 5 degrees per line
Cabin pressure system no longer can be diabled
HSI from flag was not linked to card (fixed)
HSI and ATT got a few color updates
Altitude lower deflection indicator now is for localizer only
Turn Coordinator ball updated for accuracy

Joysticks & keyboard assignments
Autopilot modes now can be assigned using the G1000 softkeys
Steer lock now can be assigned using the G1000 softkeys
Yaw damper now can be assigned using the G1000 softkeys
Spoiler switch now can be assigned using the G1000 softkeys (Default no longer works)
Read the updated user manual for details

[72westy]

Bump.